GM/Detroit 6.5L ENGINE CONTROLS – EGR Vent Solenoid Replacement

Removal Procedure
1. Remove the negative battery cables.
2. Remove the electrical connector from the solenoid.
3. Remove the vacuum hoses.
4. Remove the EGR Vent solenoid mounting bolt (2).
5. Remove the EGR vent solenoid (1).

Installation Procedure
1. Install the EGR vent solenoid (1).
Notice : Refer to Fastener Notice in Cautions and Notices.
2. Install EGR Vent Solenoid mounting bolt (2).
Tighten
Tighten mounting bolt to 6.0 N-m (53 lb in).
3. Install the vacuum hoses.
4. Install the electrical connector to the solenoid.
5. Install the negative battery cables.

Leave a Reply

Your email address will not be published. Required fields are marked *