The 4-Pin Injector Harness is used to measure continuity of the UVC wiring and injector solenoids.
Related Posts
- International DT466 - DIAGNOSTIC TOOLS AND ACCESSORIES - Tools and Accessories - Amp Clamp
The Amp Clamp is to measure amperage draw for the glow plug and inlet air…
- International DT466 - DIAGNOSTIC TOOLS AND ACCESSORIES - Tools and Accessories - 3-Banana Plug Harness
The 3-Banana Plug Harness is used for operational diagnostics of sensor circuits.
- International DT466 - DIAGNOSTIC TOOLS AND ACCESSORIES - Tools and Accessories - Breakout Harness Kit
The Breakout Harness Kit contains the following breakout harnesses and test leads: • 3-Banana Plug…
- International DT466 - DIAGNOSTIC TOOLS AND ACCESSORIES - Tools and Accessories - UVC Sensor Breakout Harness
The UVC Sensor Breakout Harness is used to access VREF, signal ground, and signal voltage…
- International DT466 - DIAGNOSTIC TOOLS AND ACCESSORIES - Tools and Accessories - EZ-Tech® Interface Kit
These interface cables, included with the EZ-Tech®, connect the EST to Electronic Control Module (ECM).…
