Home » John Deere » 1025R » John Deere – 1023E, 1025R and 1026R – Reverse Pedal Switch Adjustment

John Deere – 1023E, 1025R and 1026R – Reverse Pedal Switch Adjustment

[1] –

[2] – Remove center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.)

[3] – Remove seat base. (See Remove Seat Base in Section 90, Group 15.)

[4] –
→NOTE:
The top edge of the switch flange should be in line with the top edge of the
bracket.

Confirm that the top edge of reverse pedal switch (A) mounting flange is in line with the top edge of bracket (B).

[5] – If adjustment is necessary, loosen nuts (C) on screws (D).

[6] – Align top of reverse pedal switch (A) mounting flange with top of bracket (B). Tighten nuts (C) on screws (D) to specification.

[7] – Using hydro pedals move bell crank (F) away from reverse pedal switch (A) plunger.

[8] –

[9] – If adjustment is necessary, loosen nut (G) and adjust setscrew (H) to correct dimension.

[10] – Maintain the position of setscrew (H) and tighten nut (G) to specification.

[11] – Perform reverse pedal switch test. (See Reverse Pedal Switch Test in Section 240, Group 15.)

[12] – Install seat base. (See Install Seat Base in Section 90, Group 15.)

[13] – Install center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.)