KUBOTA – L2501 – CLUTCH – Steering Joint Shaft and Accelerator Rod

1. Remove the screw from support (1) and the steering joint shaft (2).
2. Remove the accelerator rod (3).

(When reassembling)
• Lift the universal joint so that there should be a clearance (A) of more than 5 mm (0.2 in.) between the universal joint and flywheel housing.
Then fit the support (1) in position.
• Be sure to insert the screw (2) into cut-off part of joint shaft (1).
• Apply grease to spline part of joint shaft (1).