KUBOTA – L2501 – ELECTRICAL SYSTEM – CHECKING AND ADJUSTING – ENGINE STARTING AND STOPPING SYSTEM – Checking Alternator

Related Posts

• KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking Seat Switch

  1. Remove the seat. 2. Disconnect the seat switch connector (3). 3. Change the sensor…

• KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking OPC Timer

  1. Remove the timer. (OPC timer is located behind the panel.) 2. Connect jumper leads…

• KUBOTA - L2501 - TRANSMISSION - SERVICING - Checking Bearing

  1. Hold the inner race, and push and pull the outer race in all directions…

• KUBOTA - L2501 - TRANSMISSION - CHECKING AND ADJUSTING - Checking Cruise Lever Operating Force (Option)

  1. Push the cruise control lever (1) into maximum tied position. After that pull it…

• KUBOTA - L2501 - TRANSMISSION - CHECKING AND ADJUSTING - Adjusting Neutral

  1. Disengage the front wheel drive lever. (Drive only rear wheels.) 2. Set the cruise…