Home » 5.7 Hemi » 5.7 Hemi – SOLENOID-MDS – INSTALLATION

5.7 Hemi – SOLENOID-MDS – INSTALLATION

1. Verify that MDS bores are free of debris, before solenoid installation.
2. Install MDS solenoid{s) (3) fully into block.
3. Install hold down bolt (2) and tighten to 11 N·m (97 in. Ibs.).
4. Reconnect the MDS wiring harness to the solenoid(s) (3).
5. Install foam insulator pad (1) if removed.
6. Install the intake manifold. (Refer to 9 – ENGINE/
MANIFOLDS/INTAKE MANIFOLD INSTALLATION).