Cummins N14 – Coolant Inlet Transfer Connection – Installation

Install the coolant inlet transfer connection and a new gasket on the water pump.
Tighten the capscrews.
Torque Value: 47 N•m [35 ft-lb]

Cummins N14 - Coolant Inlet Transfer Connection - Removal
Loosen four mounting capscrews, and remove the cool- ant inlet transfer connection from the water…
Cummins N14 - Coolant Filter - Removal
Use a water and fuel filter wrench, Part No. 3376807, to remove the coolant filter.
Cummins N14 - Coolant Temperature Sensor - Installation
Make sure the sensor has an o-ring. Install the sensor in the engine. Tighten the…
Cummins N14 - Lubricating Oil Transfer Tube - Removal
Remove the two capscrews from the flange at the oil pan and also the two…
Cummins N14 - CELECT Coolant Temperature Sensor Location & Removal
Note: The N14 water temperature sensor is directly connected to the thermostat Remove the coolant…

Published by samuel