Cummins ISX11.9 CM2250 – Service Manual 001-057   Engine Dataplate

The engine dataplate is typically located on the left side of engine, rear of center, at the top of the cylinder block, or below the cylinder head on the block.

Two types of dataplates are typically used:

1. Metal stamped dataplate which is riveted in place
2. A printed plastic dataplate label adhered in place.

If the dataplate is damaged, missing, or incorrect, contact a Cummins® Authorized Repair Location to obtain a new dataplate.

For metal stamped dataplates, remove the rivets securing the engine dataplate.

NOTE: If the dataplate is to be reused, care must be taken to not damage the data on the plate.

Use a flat chisel and hammer to drive the chisel under the head of the rivet and pry the rivet out.

For printed plastic dataplates, use the sharp edge of a gasket scraper, peel up a corner of the dataplate. Then pull on the corner to remove the dataplate.

NOTE: In most instances the dataplate will be damaged during removal. Contact a Cummins® Authorized Repair Location to obtain a new dataplate.

WARNING  When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer’s recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury.

WARNING  Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury.

Use solvent to clean the area where the dataplate will be mounted.

Remove any excess adhesive from the printed plastic dataplate. Use solvent with an abrasive pad, Part Number 3823258 or equivalent.

Dry with compressed air.

CAUTION  When drilling holes for the dataplate location, do not completely drill through the mounting location. Only drill deep enough to install the new blind rivets. Drill through will result in an oil leak.

For metal stamped dataplates, if attaching the dataplate to a new component or if the old rivet locations are damaged, drill new holes and attach with new blind rivets.

NOTE: The dataplate should be located in the same area as it was previously installed.

Install the dataplate with new blind rivets.

Drive the rivets until they contact the dataplate.

For printed plastic dataplates, peel the backing off the new dataplate.

Apply the new dataplate to the appropriate mounting surface.

Rub the dataplate with a clean rag to work out any air bubbles and to adhere the dataplate to the mounting surface.

NOTE: The dataplate should be located in the same area as it was previously installed.