The oil consumption can be measured using the oil dipstick with the millimeter scale as well as the accompanying diagram on the back of the…
Author: samuel
Total pressure loss max. 25 % at valves and cylinder head gasket max. 10 % at pistons and piston rings max. 20 % 1 Warm…
Testing data in bar positive for hot engine Compression pressure normal 22-24 Minimum compression pressure ca. 15 Permissible difference between any two cylinders max. 3…
#042 Inspection of stop lamp switch • If any fault is found, replace the switch. #302 Inspection of brake fluid pressure sensor • Apply voltage…
Installation sequence Follow the removal sequence in reverse. Repair kit: Service Kit A (Part No.: MK443502), Service kit C (Part No.: MK443504) Work before removal…
Work before installation Draining of coolant • Perform draining of coolant in the high voltage cooling system. (See “ON-VEHICLE INSPECTION AND ADJUSTMENT”.) Installation procedure •…
[Removal] • Remove the cover. • Remove the air filter by pulling it out while lifting it. [Inspection] • Check the air filter and clean…
• Open the radiator drain cock to drain coolant around the radiator. • Disconnect the water hose (between the motor electronic control unit and the…
• After driving, check the radiator, reservoir tank, water pump, water hose, motor electronic control unit, etc. for coolant leakage with the engine idling. •…