1. Loosen the charged air cooler inlet duct connector to turbocharger clamp (1). IMPORTANT: Do not use a screwdriver or other tool to pry the…

1. Position the engine mount frame bracket on the frame. Do not install the bolts. 2. Install the engine mount. 3. Perform the following procedure…

1. Remove the starter motor. Refer to Starter Motor Replacement (6 .6 L ). 2. If RW D vehicle, raise the vehicle to a height…

1. Position the engine mount frame bracket on the frame. Do not install the bolts. 2. Install the engine mount. 3. Perform the following procedure…

1. If RWD vehicle, raise the vehicle to a height to work through the front wheelhouse opening. Refer to Lifting and Jacking the Vehicle .…

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle . 2. Remove the oil pan skid plate. 3. Remove the engine protection shield.…

1. Install the intake manifold cover. 2. Tighten the intake manifold cover bolt (2) until snug. NOTE: Refer to Fastener Notice . 3. Tighten the…

1. Loosen the intake manifold cover clamp (1) at the resonator. 2. Loosen the intake manifold cover bolt (2). 3. Remove the intake manifold cover.

1. Install the right side idler pulley and bolt (1). Tighten: Tighten the bolt to 50 N.m (37 lb ft). 2. Install the center idler…

1. Remove the drive belt. Refer to Drive Belt Replacement. 2. Remove the bolt (1) from the right side idler pulley. 3. Remove the idler…