Rear Gear Train Remove the front gear cover mounting capscrews. Remove the front gear cover. Front Gear Train Remove the front gear cover mounting capscrews.…

Prior to any reconditioning of the cylinder bores, make sure to cover the lubricating holes and tappet holes in the top of the cylinder block…

All measurements of the cylinder block must be made when the cylinder block is positioned on a flat surface with the main bearing caps installed.…

Inspect all pipe plugs for signs of damage or leaks.Refer to Procedure Procedure 017-007 in Section 17. Inspect all expansion plugs for signs of damage…

Before cleaning or further disassembly of the block, perform a visual inspection to see if there is any damage (cracks, fretting, etc.) that will prohibit…

Prior to removing the piston and connecting rod assemblies, measure and record piston protrusion. Refer to Procedure 001-054 in Section 1. Measuring piston protrusion prior…

The cylinder block uses bored cylinders as opposed to liners. In the event of cylinder damage or wear out, the cylinders may be able to…

Use the Crankshaft Front Wear Sleeve Installation Tool, Part No. 3824500, to install the wear sleeve. The driver will be used to install the wear…

Using solvent, clean the oil and seal residue from the crankshaft surface. Dry with compressed air. Use a crocus cloth to remove any rust or…

If a wear sleeve has previously been installed, use a dull chisel that is only as wide as the wear sleeve. Make one or two…