Install Front Gear Train Install and tighten the fuel rail supply line at the fuel pump and the fuel rail. Torque Value: 40 N•m [ 30…

Install Front Gear Train Install a new seal ring on the front of the fuel pump assembly. Be sure the seal ring is not twisted.…

Install Install and hand-tighten all of the fuel lines. Tighten the injector high-pressure supply lines. Torque Value: 40 N•m [ 30 ft-lb ] Tighten the…

Install Install the fuel rail on the engine. Hand tighten the fuel rail mounting capscrews. NOTE: Before tightening the fuel rail mounting capscrews, the injector…

Install NOTE: If the injector was removed along with the fuel connector, the installation steps must be followed. Refer to Procedure 006-026 in Section 6.…

Install Verify that the new injector sealing washer is the correct thickness. NOTE: Sealing washers are configured in a flat (1) or saucer (2) shape.…

Install If previously taped off, remove the tape from the cylinder head prior to installing the intake manifold. Install the air intake manifold to the…

General Information Different lubricating oil filters are available. Reference the appropriate Part Information resources when replacing the lubricating oil filter so that the correct lubricating…

Install Fill the turbocharger oil inlet with clean 15W-40 engine oil. Install the oil supply line at the turbocharger bearing housing and the oil filter…

Install Apply a thin film of clean engine oil to the drain line a-rings. Push the drain line into the oil drain line boss. Make…