Install the mounting plate. Tighten the two capscrews. Torque Value: 68 N•m [50 ft-lb] Install the STC oil control valve to the mounting plate with…

Install the actuator harness on the engine. Install the actuator harness amp connector to the ECM. Tighten the two connector capscrews to the ECM. Torque…

Install the sensor wiring harness on the engine. Install the sensor harness amp connector to the electronic control module (ECM). Tighten the connector capscrews to…

Install theECMto the cooling plate. Tighten the six metric capscrews. Torque Value: 7.3 N•m [65 in-lb] Make sure the star washer is installed under one…

Install the sensor on the engine. Tighten the capscrews. Torque Value: 30 N•m [22 ft-lb] Push the connectors together until they lock.

Install the sensor on the engine. Tighten the capscrews. Torque Value: 30 N•m [22 ft-lb] Install the oil pressure signal line. Push the connectors until…

Install the cooling plate. Install the heat resistant grommets on both sides of the cooling plate. Install the two heat resistant star washer grommets at…

Install the spider coupling, the mounting gasket, and the fuel pump. Tighten the pump mounting capscrews. Torque Value: 47 N•m [35 ft-lb] Connect the fuel…

Install the splined coupling on the accessory drive. Make sure the gasket surfaces of the accessory drive and the air compressor are clean and not…

Install fuel supply tube and fuel return tube to the engine. Tighten the tube nuts to the torque value specified for the size of the…