Visually inspect the pulley alignment. Pulley misalignment must not exceed 0.5mmper cm [1/16-inch per foot] of distance between the pulley centers. Inspect, repair, or replace…

Install the following pieces on the engine and tighten the capscrews. Torque Values: • Fan Hub Bracket to Block – 100 N•m [75 ft-lb] •…

NOTE: If rubber grommets are used on the coolant lines, be sure they are installed carefully to prevent cuts or tears to the grommets which…

Make sure the sensor has an o-ring. Install the sensor in the engine. Tighten the sensor. Torque Value: 34 N•m [25 ft-lb] Push the electrical…

Install the water transfer tube with new o-rings into the water pump housing. Apply a non-petroleum based lubricant such as soap or vegetable oil to…

Visually inspect the pulley alignment. Pulley misalignment must not exceed 0.5mmper cm [1/16-inch per foot] of distance between the pulley centers. Inspect and repair or…

Caution: The water pump must have a dowel pin locating hole (1) and oil cooler return passage (2). Engine damage will occur due to lack…

Install two guide pins into the end of the crankshaft. Install the pulley and the vibration damper. NOTE: Make sure the mounting surfaces of the…

Install the engine support bracket and the eight mounting capscrews. Tighten the capscrews. Torque Value: 68 N•m [50 ft-lb]  

Connect the following lines to the STC oil control valve and tighten them to the specified torque: 1. Fuel pressure sensing line – 9.5 N•m…