Installation: Flywheel • Tighten the flywheel mounting bolts to a torque of 39 N·m {4.0 kgf·m}. • After installing, give the bolts a further 30°…

Inspection: Wear of the ring gear [Inspection] • If the measurement exceeds the limit, replace the ring gear. Replacement of the ring gear [Removal] •…

•Inspection: Flywheel friction surface runout If the runout exceeds the specified limit, check that the bolts are tightened correctly and that there are no abnormalities…

Disassembly sequence 1 Washer 2 Pilot bearing 3 Ring gear 4 Flywheel Locating pin • Do not remove the pilot bearing and ring gear unless…

Installation: Connecting rod bolts • Check that there are no burrs or other defects on the surface of the connecting rod bolt holes. Replace the…

•Inspection: Piston ring end gap – Using the crown of a piston, push the piston ring horizontally into a cylinder in the crankcase until it…

• Removal: Piston ring • Removal: Piston pin Remove the piston pin by striking it with a rod and hammer. If the piston pin is…

Installation: Connecting rod bearings • Select and use a bearing set of a thickness that can accommodate the inside diameter of the connecting rod’s large…