[1] – Install the ROPS to the machine frame, aligning all mounting holes. [2] – Install two M12x35 hex bolts (A) through ROPS crossbar bracket,…

The roll-over protective structure (ROPS) should only be removed as required for machine repair procedures. The ROPS must be reinstalled before the machine is put…

[1] – Install seat switch wire harness through openings in seat base. [2] – Align seat track mounting holes with front and rear mounting brackets.…

[1] – Remove center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.) [2] – Slide seat fully rearward, and…

[1] – Position seat over seat base. [2] – Insert hinge pin (A) through mounting tabs on seat and base. [3] – Secure hinge pin…

[1] – Park machine safely. [2] – Tip seat forward. Remove wire harness connector (A) from seat switch. [3] – Pass wire harness through openings…

[1] – Remove mid-mount mower deck, if installed. [2] – Park machine safely. [3] – Remove locking pins securing drilled pins (A). Support draft arms…

[1] – Install and secure elbow fitting (A) to lift cylinder [2] – Push rod fully into cylinder. [3] – Remove hex nut and carriage…

[1] – Remove mid-mount mower deck, if installed. [2] – Adjust height of cut control to install position, and fully lower mid mount rockshaft. [3]…

[1] – Park machine safely. [2] – Remove four fasteners (A) securing steering pedestal cowl. Remove cowl. [3] – Rotate height of cut adjuster control…