[1] – Remove mid-mount mower deck, if installed.
[2] – Adjust height of cut control to install position, and fully lower mid mount rockshaft.
[3] – Park machine safely.
[4] – Remove four fasteners (A) securing steering pedestal cowl. Remove cowl.
[5] – Rotate height of cut adjuster control (B) to lowest (install) position. Remove control knob.
[6] – Remove center closeout panel (C). (See Remove and Install Center Closeout Panel in Group 90, Section 15.)
[7] – Remove ten hex shoulder bolts (D) and washers securing foot rest. Remove foot rest.
[8] – Place suitable container below hydraulic lift cylinder to contain lost fluid.
[9] – Remove three tie wraps (E) securing hose to support bracket.
[10] – Remove hose end fitting (F) from hydraulic cylinder elbow.
[11] – Retain orifice (G) installed to hose end fitting. Cover fitting to prevent entry of dirt.
[12] – Remove hose from foot rest bracket.
[13] – Remove two hex nuts (H) securing hose retainers to front seat rail bolts. Remove retainers from hose.
[14] – Withdraw hose through opening (I) between fender and SCV support bracket.
[15] – Remove fasteners (J) from two hose retainers securing hose to hydraulic pipe. Remove hose from retainers.
[16] – Remove hose fitting from quick-connect coupler.
[17] – Remove hose.
[18] – Remove locking pin and drilled pin (K) securing cylinder rod to rockshaft arm.
[19] – Remove hex nut (L) securing fuel hose retainer.
[20] – Remove locking pin and drilled pin (M) securing cylinder to bracket.
[21] – Remove cylinder.
