[1] – Install the ROPS to the machine frame, aligning all mounting holes.
[2] – Install two M12x35 hex bolts (A) through ROPS crossbar bracket, and loosely secure with hex nuts.
[3] – Align flat on draft arm pivot pins (B) to ROPS mounting plate. Install pins through left and right ROPS mounting plates, machine frame, and outside plates. Loosely secure pins with hex nuts.
[4] – Install M12 hex bolt and three carriage bolts (C) through machine frame and ROPS mounting plates at each side. Secure carriage bolts with nuts.
[5] – Raise rockshaft lift arms and check clearance between lift arm and crossbar.
[6] – If minimum clearance is not present, adjust ROPS to attain clearance.
[7] – Tighten fasteners to specification.
