[1] – Remove tilt steering assembly. (See Remove and Install Tilt Steering Assembly in this Group.) [2] – Remove snap ring (A) and backet (B).…

[1] – Remove steering wheel and control panel. (See Remove Control Panel in Section 90, Group 15.) [2] – Remove two cap screws (A) on…

[1] – →NOTE: Cylinder ball end studs are tapered. Use a tie rod end removal tool to avoid damaging threads if cylinder is to be…

[1] – Disengage three locking tabs at underside of steering wheel and remove steering wheel cover. [2] – Remove nut securing steering wheel. [3] –…

[1] – Install pinion gears (A) and cupped washers (B) to partially installed pinion shaft. [2] – Install pinion shaft to carrier, aligning carrier and…

Rotate the differential case bearings to check bearing condition. Inspect the differential gear condition. Replace components as needed. [1] – Rotate side gear assemblies (A)…

[1] – Install new seal (A) to bottom of bevel gear housing bore. [2] – Lubricate seal and axle stub shaft with lithium grease. Install…

Service procedures are the same for the left and right side outer axle assemblies. Rotate outer axle end bearings to check bearing condition. Inspect gears,…

[1] – Lubricate bearings with clean hydraulic oil and install input shaft assembly to axle housing. [2] – Install snap ring (A) securing input shaft…

Service procedures are the same for the left and right side outer axle assemblies. Only the right side outer axle assembly must be removed to…