[1] – Install bushings (A) into housing.
[2] – Install sector gear into bracket making sure raised area (B) is properly engaged in hole.
Install cap screw and tighten nut (C).
[3] – Install the pawl (D) with the offset (E) toward the housing.
[4] – Hold pawl (F) out and install tilt assembly (G) into bracket.
[5] –
IMPORTANT:
Square shoulder on pivot bolt needs to be fully engaged in mating hole in bracket.
Install a pivot bolt (H) in each side and secure with flange nut.
[6] – Snap lever (I) into place and install spring (J).
[7] – Install spring (K).
[8] – Install steering shaft (L).
[9] – Install bracket (M) and snap ring (N).
[10] –
IMPORTANT:
Verify function of mechanism prior to install. Tilt lever must seat on its own when released.
Install tilt steering assembly. (See Remove and Install Tilt Steering Assembly in this Group.)
