1. Remove the bushings right (4) and left side (3). (When reassembling) • When press-fitting new bushings (3), (4) with a press-fitting tool (see page…

1. Disconnect the position control rod from feedback lever. 2. Remove the lift arm setting screws. 3. Draw out the hydraulic arm shaft (5) and…

1. Tap out the spring pin. 2. Remove the hydraulic rod. 3. Push out the hydraulic piston (1). (When reassembling) • Install the piston, noting…

1. Remove the lowering speed adjusting valve from hydraulic cylinder block. 2. Tap out the spring pin (8), and remove the grip (5). 3. Remove…

1. Loosen and remove the hydraulic cylinder assembly mounting screws and nuts. 2. Support the hydraulic cylinder assembly with nylon lift strap and hoist, and…

1. Remove the support (1) and the position lever (5). 2. Remove the joint screw (2). 3. Remove the clips (3). 4. Disconnect the wirings…

1. Remove the seat (1). 2. Remove the grip (2). 3. Remove the grip (4) [4WD]. 4. Remove the position control lever guide (3). 5.…

1. Remove the top link (1). 2. Remove the rubber spring (2) and lift-rods (3). 3. Disconnect the negative cable.  

1. Remove the drain plugs (1) at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining…

After reassembly, perform break-in operation in the following manner, and check the pump for abnormality before use. If the pump temperature should rise noticeably during…