KUBOTA – L2501 – HYDRAULIC SYSTEM – DISASSEMBLING AND ASSEMBLING – Lift-rod and Battery Negative Cable

1. Remove the top link (1).
2. Remove the rubber spring (2) and lift-rods (3).
3. Disconnect the negative cable.

KUBOTA - L2501 - ENGINE - Push Rod Alignment
1. Place the push rod on V blocks. 2. Measure the push rod alignment. 3.…
KUBOTA - L2501 - ENGINE - Connecting Rod Alignment
1. Install the piston pin into the connecting rod. 2. Install the connecting rod on…
KUBOTA - L2501 - REAR AXLE - DISASSEMBLING AND ASSEMBLING
1. Remove the ball bearing (9) with a puller. 2. Remove the stake of lock…
KUBOTA - L2501 - TRANSMISSION - PREPARATION - HST Neutral Rod, Clutch Rod and Steering Support
1. Remove the suction pipe (1) and the filter bracket stay (2). 2. Disconnect the…
KUBOTA - L2501 - TRANSMISSION - PREPARATION - Hydraulic Pipes, HST Neutral Rod and Clutch Rod
1. Remove the front step bracket (R.H.) (1) and filter bracket stay (2). 2. Disconnect…

Published by samuel