The front hydraulic block (2) is provided to take power out from the tractor to operate the hydraulic cylinders on the implement, such as front…
Category: KUBOTA
The cylinder safety valve (1) is equipped on the hydraulic cylinder assembly (2). This model uses a direct acting safety valve which is suitable for…
The gear type hydraulic pump is adopted for these models. This pump is called as tandem type and composed two pair of gears, side plates,…
When moving the position control lever from “LIFTING” to “NEUTRAL”, the spool (1) is pushed back as shown in the figure. When the “NEUTRAL” position…
When the control lever is moved to “DOWN” position, the spool (1) is pushed into the position control valve body as shown in the figure.…
When the control lever is moved to “UP” position, the spool (1) is pulled out from the position control valve body as shown in the…
Pressurized oil delivered from the P port, pushes the unload poppet (2) and returns to the transmission case from T1 port. Since the poppet 1…
4. When the position control lever is moved to the Lowering position, the control arm (2) rotates to the arrow. …
1. When the position control lever is moved to the LIFT position, the control arm (2) rotates to the arrow. Therefore, the spool drive lever…
Position control is a mechanism to raise or lower the implement attached to the tractor in proportion to the movement of the position control lever…