1. Remove the steering wheel (1) with steering puller and the rubber steering cover (10). 2. Remove the throttle grip (2). 3. Remove the rear…

1. To open the bonnet (1), hold the bonnet with a hand and pull the release lever and open the bonnet. 2. Disconnect the battery…

1. Remove the drain plugs (1) at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining…

1. Stop the engine and remove the key. 2. Slightly depress the clutch pedal and measure free travel at top of pedal stroke. 3. If…

The clutch is located between the engine and transmission and is operated by stepping on the clutch pedal. When the clutch pedal is depressed, the…

1. Put a strip of plastigauge on the rotor face with grease. 2. Install the cover and tighten the screws. 3. Remove the cover carefully.…

1. Measure the clearance between the lobes of the inner rotor and the outer rotor with a feeler gauge. 2. Measure the clearance between the…

1. If the cylinder wear is more than the allowable limit, bore and hone it to the specified dimension. 2. Replace the piston and piston…

1. Measure the I.D. of the cylinder at the 6 positions (see figure) with a cylinder gauge. 2. Find the maximum and minimum inner diameters.…

1. Remove the used crankshaft sleeve (3). 2. Set the sleeve guide (2) to the crankshaft (5). 3. Set the stopper (1) to the crankshaft…