FUSO 4M4 – LUBRICATION – OIL PAN, OIL STRAINER AND OIL JET – Installation procedure

Installation: Oil pan
• Clean the sealant application surfaces of each part.
• Apply a bead of sealant to each of the mating surfaces of the timing gear case, lower crankcase and front plate (at the two locations indicated in the illustration).

• Clean the mating surfaces of each part.
• Apply a bead of sealant to the mating surface of the oil pan evenly and without any breaks.
• Mount the oil pan within three minutes of applying the sealant.
Make sure that the sealant stays in place.

 

Leave a Reply

Your email address will not be published. Required fields are marked *