Home » John Deere » 1025R » John Deere – 1023E, 1025R and 1026R – Remove and Install Flywheel

John Deere – 1023E, 1025R and 1026R – Remove and Install Flywheel

[1] – Remove engine. (See Remove Engine in this Group.)

[2] –
IMPORTANT:
FLYWHEEL IS HEAVY! Do not remove flywheel mounting bolts unless flywheel is secure. Use a hoist and lift rings, or get help to lift flywheel from crankshaft.

Remove five flywheel mounting cap screws (A).

[3] – Pull flywheel from crankshaft alignment pin.

[4] – Inspect flywheel ring gear teeth for wear or chips.

[5] –
IMPORTANT:
Always install new flywheel mounting cap screws.

Install flywheel:
a. Align flywheel on alignment pin and install five new flywheel mounting cap screws.
b. Tighten cap screws to specification.