Home » John Deere » 1025R » 1023E, 1025R and 1026R – Remove and Install Oil Pan and Strainer: 3TNV76 and 3TNV80

1023E, 1025R and 1026R – Remove and Install Oil Pan and Strainer: 3TNV76 and 3TNV80

[1] –
→NOTE:
Approximate oil pan capacity is 2.6 L (2.75 qt.).
Drain oil.

[2] – Remove cap screws from oil pan (G) and remove pan.

[3] – Remove cap screws (C) from strainer (A) and remove strainer and O-ring.

[4] – Clean and inspect all parts. Make sure that all gasket material has been removed from mating surfaces.

[5] – Install new O-ring on strainer tube and install strainer.

[6] – Apply a thin bead of John Deere Form-in-Place Gasket to engine block and install oil pan spacer.

[7] – Apply a thin bead of John Deere Form-in-Place Gasket to spacer.

[8] – Install pan, and cap screws. Tighten to specifications.

[9] – Fill engine with correct engine oil. (See Section 10, Group 15.)