[1] – Install fender over SCV, SCV lock, and rockshaft controls.
[2] – Arrange fender wire harness (A) along top of fender.
[3] – Lift edge of foot rest to fit fender flange under foot rest.
[4] – Loosely install foot rest bolts (B) and washers.
[5] – Install console cover to fender over SCV and rockshaft controls.
[6] – Connect wire harness connectors to worklight and accessory outlet (C).
[7] – Lower console cover to fender, fitting wire harness into notches (D) in underside of cover.
[8] – Install handle (E) to fender, fitting studs through cover, fender, and support bracket.
Install and tighten two hex lock nuts.
[9] – Install two hex bolts (F) with flat washers securing fender to bottom bracket.
[10] – Install knob (G) to SCV lock shaft.
[11] – Tighten foot rest bolts until shoulder is seated. Do not overtighten.
