[1] – Remove cap from steering wheel.
[2] – Remove nut securing steering wheel.
[3] – Remove steering wheel using an appropriate puller if necessary.
[4] – Remove two cap screws (A) securing instrument panel to firewall.
[5] – Remove four screws (B), one from each side of cowl panel and two in center.
[6] – Remove two screws (C).
[7] – Pull instrument panel back 2.5-5 cm (1-2 in.) from firewall and disconnect park brake rod (D) from handle.
[8] –
→NOTE:
The current model has two connectors at top and one at bottom.
Disconnect three connectors (E) from display module.
[9] – On right side of instrument panel, disconnect PTO switch (F) and key switch (G).
[10] – On left side, disconnect turn signal connector (H) and headlight switch (I).
[11] – Lift control panel carefully, guiding throttle lever through opening.
[12] – If removing display module, remove eight screws (J).
