John Deere - 1023E, 1025R and 1026R - Remote Cylinder Does Not Extend or Retract

CONDITIONS:
– Machine parked on level surface.
– Key switch in OFF position.
– Hydraulic tests and adjustments in this section.

1023E, 1025R and 1026R - Recondition Cylinder Head - Cylinder Head
Measure cylinder head flatness. Place a straight-edge along each of the four sides and each…
1023E, 1025R and 1026R - Rebore Cylinder
[1] - →NOTE: The cylinder block can be rebored to use oversize pistons and rings.…
1023E, 1025R and 1026R - Inspect Cylinder Bore
Cylinder Bore Measurement Inspection Measure cylinder bore diameter at three positions; top, middle, and bottom.…
1023E, 1025R and 1026R - Disassemble and Assemble Cylinder Head
[1] - Compress valve springs (A) using JDE138 Valve Spring Compressor. [2] - Remove collet…
John Deere - 1023E, 1025R and 1026R - Remove and Install Steering Cylinder
[1] - →NOTE: Cylinder ball end studs are tapered. Use a tie rod end removal…

John Deere – 1023E, 1025R and 1026R – Remote Cylinder Does Not Extend or Retract