Home » John Deere » 1025R » John Deere – 1023E, 1025R and 1026R – Remove and Install Fuel Transfer Pump

John Deere – 1023E, 1025R and 1026R – Remove and Install Fuel Transfer Pump

[1] – Park machine safely.

[2] – Allow engine to cool.

[3] – Close fuel shutoff valve at the fuel filter and water separator.

[4] –
→NOTE:
Clamp or pinch inlet hose end to prevent draining from tank due to gravity.

Remove inlet and outlet hose clamps (A) at fuel transfer pump and disconnect hoses.

[5] – Disconnect wiring harness at connector (B).

[6] – Remove two fuel pump mounting cap screws (C).

[7] – Install pump in the reverse order of removal.

Turn on fuel shutoff valve and turn key switch to ON position for 20 or 30 seconds to bleed air from system.