Home » 2008 6.6L Duramax » 2008 6.6L Duramax – CAMSHAFT RELUCTOR REPLACEMENT – Installation Procedure

2008 6.6L Duramax – CAMSHAFT RELUCTOR REPLACEMENT – Installation Procedure

1. Position the camshaft reluctor to the camshaft gear.
2. Install the camshaft reluctor bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).

3. Install the oil pump drive gear and reluctor to the crankshaft.

4. Install the oil pump driven gear.

NOTE: Do not use an impact driver to remove or install the oil pump driven gear nut. Use of an impact driver may                    shear the oil pump drive gear pin in the crankshaft.

5. While holding the secondary oil pump shaft with a hex driver, install the oil pump driven gear nut.

Tighten: Tighten the nut to 100 N.m (74 lb it).
6. Install the upper oil pan. Refer to Upper Oil Pan Replacement.
7. Install the engine front cover. Refer to Engine Front Cover Replacement.