Home » ISX11.9 CM2250 - Service Manual » Cummins ISX11.9 CM2250 – Service Manual 007-011   Lubricating Oil Dipstick Tube

Cummins ISX11.9 CM2250 – Service Manual 007-011   Lubricating Oil Dipstick Tube

Table of Contents

Remove
Install

Remove

TOC

NOTE: There are four potential dipstick tube locations. Threaded plugs are installed in locations not in use.

NOTE: Some options include a bracket.

Remove the dipstick.

Remove the dipstick tube P-clip capscrew and P-clip.

Loosen the compression nut on the tube-to-block connector. If a new dipstick is installed, the tube-to-block connector must be replaced.

Remove the dipstick tube.

Remove the dipstick tube bracket, if necessary.

SMALL | MEDIUM | LARGE

Install

TOC

Install a new tube-to-block connector, if necessary.

Torque Value:  27  n.m  [239 in-lb]

Install the dipstick tube bracket onto the cylinder block, if removed.

Torque Value:  47  n.m  [35 ft-lb]

Install the dipstick tube bracket onto the intake manifold, if removed.

Torque Value:  20  n.m  [177 in-lb]

SMALL | MEDIUM | LARGE
   


Install the dipstick tube into the tube-to-block connector.

Tighten the compression nut.

Torque Value:  27  n.m  [239 in-lb]

Install the dipstick tube P-clip capscrew and P-clip.

Tighten the capscrew finger-tight into the bracket.

Tighten the P-clip capscrew.

Torque Value:  20  n.m  [177 in-lb]

Install the dipstick into the dipstick tube.

SMALL | MEDIUM | LARGE
Last Modified:  14-Jun-2010