Install
NOTE: If installing a new turbocharger, orient the compressor housing to the same position as the turbocharger that was removed. Orient the housing by loosening the v-band clamp and then positioning the housing in the correct location. Do not orient the turbine housing.
Torque Value: 8 N•m [ 71 in-lb ]
Apply a film of high-temperature anti-seize compound to the turbocharger mounting studs.
Only remove Clean Care caps as the connections are being made.
Use a new gasket and install the turbocharger.
Install and tighten the four mounting nuts.
NOTE: The torque values given have been established using anti-seize compound as a lubricant.
Torque Value: 55 N•m [ 41 ft-lb ]
Prime
Install and tighten the turbocharger oil drain line. Refer to Procedure 010-045 in Section 10.
Lubricate the bearings by pouring 59 to 89 cc [2 to 3 oz] of clean 15W-40 engine oil in the turbocharger oil supply
line fitting.
Rotate the turbine wheel to allow oil to enter the bearing housing.
NOTE: If too much oil is poured into the bearing housing, the oil may leak past the seals. This is not a malfunction
since the seals are not dynamic and rely on exhaust gas and boost pressure to provide a proper seal.
Install the turbocharger oil supply line. Refer to Procedure 010-046 in Section 10.
