Install the sensor wiring harness on the engine.
Install the sensor harness amp connector to the electronic control module (ECM). Tighten the connector capscrews
to the ECM.
Torque Value: 2.0 N•m [18 in-lb]
Install the sensor wiring harness retaining clamps to the support bracket and the engine block.
Torque Value: 20 N•m [15 ft-lb]
Install the mounting hardware and connect the following sensors to the sensor harness.
Oil pressure sensor
Oil temperature sensor
Ambient air pressure sensor
Fuel shutoff control wire
Engine position sensor
Coolant temperature sensor
On engines equipped with engine brakes, connect the engine brake harness to the sensor harness.
Wire tie the harness to the fuel tubing at the rear of the engine.
