Begin with a thorough visual inspection of the engine, particularly at the area of the suspected leak. If an oil leak source is not readily…

1. Remove oil pressure sending unit and install gauge assembly (special tool #C-3292A, Gauge, Pressure). 2. Run engine until thermostat opens. 3. Check oil pressure…

The lubrication system is a full flow filtration pressure feed type system.

NOTE: Left side shown in illustration, right side similar. 1. If removed, position the engine mount to engine block mounting brackets, install the retaining bolts…

1. Disconnect the negative battery cable (1). 2. Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL. 3. Remove the engine oil dipstick tube retaining…

1. Position the rear transmission mount isolator (2), install the retaining bolts (1) and tighten to 68 N.m (50 ft. lbs.). 2. Position the rear…

1. If removed, position the rear transmission mount bracket (2), install the retaining bolts (1) and tighten to 68 N.m (50 ft. lbs.). 2. Position…

1. Raise and support the vehicle. 2. Using a suitable jack, support the transmission. 3. Remove the rear transmission mount isolator nuts (1). 4. Remove…

1. Raise and support the vehicle. 2. Using a suitable jack, support the transmission. 3. Remove the rear transmission mount isolator bolts (2). 4. Remove…

1. Verify the MDS solenoid bores are free of debris before installing the MDS solenoid into the engine block. 2. Install the MDS solenoid(s) (3),…