This procedure describes general guidelines for setting a vehicle up for operation on a chassis dynamometer for: • Engine Testing • Engine Run-In For engine…

Remove the wire connecting the keys witch to the magnetic switch (marked S or Start) from the keys witch terminal. Connect the positive ( +)…

For engines with wet flywheel housings, apply a 1.5 to 2.0 mm [0.06 to 0.09 in] wide bead of sealant, Part Number 3164067, to the…

Use an inside micrometer or a vernier caliper to measure the distance from the starting motor mounting flange to the forward face of the front…

For engines that use wet flywheel housings, clean any left over sealant from the starting motor mounting flange on both the flywheel housing and starting…

Remove the three capscrews and the starting motor. NOTE: If equipped with a starting motor spacer, remove the spacer and clean all surfaces between the…

• Disconnect the batteries. Refer to the OEM service manual. • Identify each wire with a tag indicating location on starting motor. • Remove the…

If the starter solenoid is making a sound but the engine is not rotating, turn the keys witch to the OFF position, and attempt to…

Digital Multimeter, Part Number 3377161 Set the digital multimeter, Part Number 3377161, to measure DC volts. Connect the multi meter positive ( +) lead to…

Before troubleshooting the starter motor, make sure the battery terminals are not loose or corroded. Refer to Procedure 013-009 in Section 13.