Inspect the turbocharger compressor inlet and discharge for oil. If oil is present in the compressor intake , as well as in the discharge, check…

Remove the intake pipe from the turbocharger. See the Remove section in this procedure. Install protective caps from the Air Handling Clean Care Kit, Part…

Install a vacuum gauge or water manometer in the intake air piping. The gauge adapter must be installed at a 90-degree angle to the airflow…

Connect INSITE’M electronic service tool. From the list of “ECM Diagnostic Tests” select “Grid Heater Override”. Follow the instructions on the screen to determine if…

The cold starting aid is not a serviceable part. If the cold starting aid has cracked, broken, or melted elements, the entire air intake manifold…

• Install the charge air cooler piping. Refer to Procedure 010-019 in Section 10. • Operate the engine and check for leaks.

Install the charge air cooler. Refer to the OEM service manual for instructions.  

NOTE: If the engine experiences a turbocharger failure or any other occasion where oil or debris is put into the charge air cooler, the charge-air…

Remove the charge-air cooler. Refer to the OEM service manual. Use protective caps from the Air Handling Clean Care Kit, Part Number 4919498, to cover…