[Inspection] • Press each belt at a central portion between pulleys with a force of approximately 98 N {10 kgf} as shown in the illustration…

• The water pump has a drain hole to prevent coolant from entering the unit bearing in case of defect in the unit seal.  

• The thermostat is a bottom bypass type that uses a wax-filled pellet as its flow-regulating element. When the wax is heated, it melts from…

#001 Inspection of combination switch AK14A connector connection table • For other inspections than shown above, see Gr54. • If there is any abnormality, replace…

Removal sequence 1 Accelerator pedal (See later sections.) 2 Accelerator link (See later sections.) Installation sequence Follow the removal sequence in reverse. Removal procedure Removal:…

Removal procedure •Removal: Case – Loosen the water separator sensor and drain fuel from the case. – Remove the case using Installation procedure •Installation: Case…