The Gauge Bar Tool is used to measure intake manifold (boost) pressure, fuel system inlet restriction, fuel pressure, oil pressure, air cleaner intake restriction, and…

The Terminal Test Adapter Kit is used to access circuits in the connector harness and allows for the use of a DMM without damaging the…

The EGR Breakout Harness is primarily used to pin out the harness to look for opens and shorts. The EGR Breakout Harness is also used…

Turbo Breakout Harness is used to measure VGT actuator power, ground, and control.

The Temperature Sensor Breakout Harness enables the technician to quickly connect a voltmeter and read voltage signals for the following sensors: • Engine Coolant Temperature…

The Temperature Sensor Breakout Harness enables the technician to quickly connect a voltmeter and read voltage signals for the Intake Air Temperature (IAT) sensor.  

The Relay Breakout Harness is used to measure power from the IDM main power relay or ECM main power relay to check the operation of…

The Relay Breakout Harness is used to measure power from the IDM main power relay or ECM main power relay to check the operation of…

The Pressure Sensor Breakout Harness is used to access VREF, signal ground, and signal voltage circuits for the following sensors: • Manifold Absolute Pressure (MAP)…

The Accelerator Position Sensor (APS) / Idle Validation Switch (IVS) harness is used to measure VREF, APS signal, signal ground, IVS signal, and IVS power…