1. Remove the knuckle arm (1) and draw out the knuckle shaft (4) from the front axle. (When reassembling) • Insert the thrust ball bearing…

1. Place the disassembling stand under the transmission case. 2. Remove the tie-rod with the tie-rod end lifter. 3. Remove the front wheel. 4. Remove…

1. Place the disassembling stand under the front axle, and hang up the front bumper by the hoist to support it. 2. Remove the shaft…

1. Remove the breather pipe (1).  

1. Remove the bumper. 2. Remove the tie-rods with the tie-rod end lifter. In this case, take special care not to damage the tie-rod end…

1. Remove the screw (4) then tap out the spring pin (3). 2. Slide the propeller shaft cover 1 (5) to the front and the…

1. Place the oil pans underneath the front axle case. 2. Remove the drain plug (1) both sides and filling port plug (3) to drain…

1. Inflate the tires to the specified pressure. 2. Steer the wheels to the extreme right until the front gear case (1) contacts with the…

1. Jack up the tractor body, then loosen the lock nut (2). 2. Measure the adjusting screw tightening torque. 3. If tightening torque is not…

1. Jack up the front side of tractor. 2. Set a spring balance to the front axle flange. 3. Measure the front axle rocking force.…