1. Remove the fuel level sensor from the fuel tank. 2. Measure the resistance across the sensor terminal and its body. 3. If resistance does…

1. Measure the resistance across the switch terminal and the chassis. 2. If 0 ohm is not indicated in the normal state, the switch is…

1. Disconnect the lead from the engine oil pressure switch (1) after turning the main switch OFF. 2. Turn the main switch ON and connect…

1. Disconnect the 2P connector from the alternator after turning the main switch OFF. 2. Turn the main switch ON. 3. Connect a jumper lead…

1. Check the continuity with an ohmmeter across the 6 terminal to 13 terminal and the 6 terminal to 4 terminal on       …

1. Check the continuity with an ohmmeter across the 5 terminal to 13 terminal and the 5 terminal to 4 terminal on       …

1. Set all levers to “NEUTRAL” position. 2. Turn the main switch ON. 3. Measure the voltage with a voltmeter across the 13 terminal on…

1. Remove the steering wheel (1) with steering puller. 2. Remove the steering rubber cover and the grip (2). 3. Remove the rear bonnet (3).…

1. Turn on the turn signal switch (2) or hazard switch (3). 2. Count the number of blinking. 3. If the factory specification is not…

1. Disconnect the flusher unit connector. 2. Measure the voltage with voltmeter across the connector of wiring harness side terminal 5 and chassis. 3. If…