1. Check the whether the ground cable (1) is connected securely to the tractor chassis. 2. If the ground cable is broken or disconnected, replace…
Category: KUBOTA
1. Check the fuse. 2. If any of the fuses is blown, replace it with one having same capacity. IMPORTANT • If a fuse is…
1. Connect the 2P connector (5) to previous position of the alternator after turning the main switch OFF. 2. Start the engine and then set…
1. Turn the main switch OFF. Measure the voltage between the terminal B (1) and the chassis. 2. Turn the main switch ON. Measure the…
1. Disconnect the 2P connector (3) from alternator (2) after turning the main switch OFF. 2. Perform the following checkings.
1. Remove the timer. (OPC timer is located behind the panel.) 2. Connect jumper leads across the battery positive terminal and the timer 3 terminal,…
1. Remove the seat. 2. Disconnect the seat switch connector (3). 3. Change the sensor bar angle (1) and measure the resistance between connector terminals,…
1. Sit on operator’s seat. 2. Set the parking brake. 3. Depress the HST pedal (Forward or Reverse position) to “NEUTRAL” position. 4. Shift the…
1. Sit on operator’s seat. 2. Set the parking brake and stop the engine. 3. Shift the range gear shift lever to “NEUTRAL” position. 4.…
1) Connector Voltage 1. Turn the main switch off. 2. Disconnect the engine stop solenoid relay. 3. Measure the voltage across the terminal A and…