1. Disconnect the 2P connector from engine stop solenoid. 2. Measure the resistance between the terminal 1, terminal 2 of engine stop solenoid and body.…
Category: KUBOTA
1. Disconnect the 2P connector from engine stop solenoid. 2. Turn the main switch to “ON” position and set all levers to NEUTRAL position. 3.…
1. Disconnect the lead from the glow plugs. 2. Measure the resistance between the glow plug terminal and the chassis. 3. If 0 ohm is…
1. Disconnect the wiring lead (1) from the glow plug (2) after turning the main switch off. 2. Turn the main switch key to the…
1) Connector Voltage 1. Turn the main switch off. 2. Remove the starter relay. 3. Measure the voltage across the terminal C and chassis. 4.…
1. Disconnect the battery negative cable from the battery. 2. Disconnect the battery positive cable and the leads from the starter. 3. Remove the starter…
1. Disconnect the battery negative cable from the battery. 2. Disconnect the battery positive cable and the leads from the starter. 3. Remove the starter…
1. Measure the voltage across the B terminal and chassis. 2. If the voltage differs from the battery voltage, check the battery’s cable.
1. Disconnect the 2P connector (2). 2. Measure the resistance between connector terminals while pushing the clutch pedal switch. 3. If 0 ohm is not…
1. Disconnect the 4P connector. 2. Remove the HST neutral switch (1). 3. Push the switch and measure the resistance between terminal 1 and 2,…