[1] – Assemble shafts and idler in the reverse order of disassembly. Lubricate bearings and bearing bores with clean oil.
[2] – Install bearing to rear PTO pinion shaft (A). Install snap ring.
[3] – Simultaneously install idler gear assembly (B) and rear PTO pinion shaft (C).
[4] – Install hydraulic pump drive coupling (D).
[5] – Thoroughly clean mating surfaces of rear cover and differential housing to remove all traces of old sealant.
[6] – Install PTO output shaft and new seal in rear cover.
[7] – Apply a bead of John Deere Form-in-Place gasket maker to mating surfaces and install rear cover.
[8] – Tighten rear cover cap screws to specification.
