[1] – Disconnect negative (—) battey cable and then positive (+) battery cable.
[2] – Remove tie wrap (A) from cable boot, slide boot back.
[3] – Remove nut (B) and disconnect the positive battery cable and wires from the starter solenoid.
[4] – Disconnect the solenoid exciter wire (C).
[5] –
→NOTE:
On some models the engine mounting bracket must be removed to remove
lower cap screw (E).
Remove the two nuts (D) and cap screws (E) securing the starting motor to the engine backplate. Remove the starting motor.
[6] –
IMPORTANT:
Do not overtighten cap screws.
Install the starting motor in the reverse order of removal. Tighten starting motor cap screws to specification.
