[1] – Park machine safely.
[2] – Loosen lock nuts (A) and lift cable out of bracket.
[3] – Disconnect cable end (B).
[4] – Pinch tabs (C) together with a pliers and pull cable housing out of holder.
[5] – Disconnect cable end (D) from throttle lever.
[6] – Pull cable through grommet (E).
[7] – Install cable in reverse order of removal.
a. Route cable through grommet (E).
b. Attach cable end (D) to throttle lever.
c. Feed cable through slot in holder and snap cable housing tabs (C) into holder.
d. Attach throttle cable end (B) to injector pump lever.
e. Insert cable housing and nuts (A) into bracket.
[8] – Adjust throttle cable. (See Adjust Throttle Cable in Section 220, Group 15.)
