1. Remove ball bearing (2) and spiral bevel gear (1) as a unit with puller.
2. Remove the spring pin (4).
3. Pull out the pinion shaft (3) and remove the differential pinions (11) and differential side gears (9).
NOTE
• Arrange the parts to see their original positions.
(When reassembling)
• Apply molybdenum disulfide (Three Bond 1901 or equivalent) to the following position.
– Differential side gears (9) (contact face with differential case (7))
– Shims (8) (contact face with differential case (7))
– Differential pinions (11) (contact face with thrust collar (10))
• Install the pinion shaft (3) so that the hole on it aligns with the hole on differential case (7) and install spring pin (4) noting its direction.
