Home » ISX11.9 CM2250 - Service Manual » Cummins ISX11.9 CM2250 – Service Manual 019-376   Exhaust Gas Pressure Sensor

Cummins ISX11.9 CM2250 – Service Manual 019-376   Exhaust Gas Pressure Sensor

Initial Check

TOC

Connect INSITE™ electronic service tool and verify the exhaust pressure sensor reading with INSITE™ electronic service tool is the same as the gauge reading.

SMALL | MEDIUM | LARGE

Remove

TOC

The exhaust gas pressure sensor is located on the EGR system bracket, near the rear of the engine.

 
SMALL | MEDIUM | LARGE
   


Disconnect the wiring harness connector.

Remove the sensor.

SMALL | MEDIUM | LARGE
   

Inspect for Reuse

TOC

Inspect the sensor adapter for cracks or fretting.

Replace the adapter if any damage is found.

SMALL | MEDIUM | LARGE
   

Install

TOC

NOTE: Make sure the sealing washer is captured on the threaded portion of the sensor.

Install the sensor and tighten.

Torque Value:  13.6  n.m  [120 in-lb]

Connect the wiring harness to the sensor. An audible click will be heard when the connector locks in place.

SMALL | MEDIUM | LARGE
Last Modified:  06-Jul-2010