Position the front gear housing gasket on the alignment dowels. Use guide pins M8 x 1.25 x 50, to assist in aligning
the gasket and gear housing. Make sure to remove the guide pins after alignment.
Carefully install the gear housing.
Make sure the gasket is still in place.
NOTE: Locations numbered 1, 2, 3, 4, and 5 in the illustration use internal torx fasteners. Make sure to install
the correct fasteners in the correct location.
Install and tighten the mounting capscrews in the sequence illustrated.
Torque Value: 24 N•m [ 18 ft-lb ]
